- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- 1GB DDR3 and 64MB SDRAM
- VGA Out, Video-In, UART-to-USB, USB Host x2, Micro SD Card Socket, 1Gbps Ethernet, and GPIO Headers
- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- 1GB DDR3 SDRAM (32-bit data bus)(HPS)
- Arduino Expansion Header (Uno R3 Compatibility), Full HD HDMI Output, UART-to-USB, USB OTG Port, Micro SD Card Socket, Gigabit Ethernet and GPIO Headers
- Cyclone II EP2C20F484 with ~20,000 LEs
- 8MB SDRAM, 512K SRAM, and 4MB Flash
- Audio/Video interface, RS232, and SD card
- 同 Cyclone II Starter Kit
- Intel Cyclone V SoC FPGA,ARM Cortex-A9 双核 HPS
- FPGA:SDRAM,VGA 输出,Video 输入,ADC 接头,GPIO 接头,HSMC 接头
- HPS:DDR3,USB Host 端口,MicroSD 卡槽,以太网,UART 转 USB,LTC 接头
- 支持 Linux BSP 和 openCL BSP
- MAX 10 10M50DAF484C7G Device
- Accelerometer and 4-bit Resistor VGA
- 64MB SDRAM, x16 bits data bus
- Arduino UNO R3 and 2x20 GPIO connector
- On-Board USB Blaster (Normal type B USB)
- Replaced by DE1
- Drive up to 24 servo motors simultaneously
- MG996R Servo Motor is included
- Open source example is provided
- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- 1GB DDR3 and 64MB SDRAM
- VGA Out, Video-In, UART-to-USB, USB Host x2, Micro SD Card Socket, 1Gbps Ethernet, and GPIO Headers
- Touch & LCD Spec
- 2.4" LCD touch module with 240(H) x 320 (V) pixel resolution LCD with 65K RGB color
- Single resistive touch
- 2x20 GPIO interface
- 7" LCD, 800x480 Resolution, 24-bit Color
- Capacitive Touch, Multi-Touch Gesture Support, Single Touch Support
- 2x20 GPIO Interface, Compatible with DE2-115 / DE2 / DE3 /DE4
- Wi-Fi, using ESP-WROOM-02 module
- Bluetooth SPP, using HC-05 module
- 9-axis sensor: accelerometer,gyroscope,magnetometer
- Ambient light sensor
- Humidity and temperature sensor
- UART to USB
- 2x6 TMD GPIO Header
- Intel Stratix 10 GX/SX FPGA
- Four QSFP28(100GbE) connectors and one PCI Express (PCIe) x16 edge connector
- Four independent DDR4 SODIMM sockets (work with DDR4/QDR-II+/QDR-IV)
- Omnivision 8 Mega Pixel Image sensor
- Voice Coil Motor (VCM) for focus control
- MIPI Decoder
- 2x20 GPIO to compatible with DE series FPGA Board
- Configurable digital interface to a processor—RF front end with a flexible mixed-signal baseband section and integrated frequency synthesizers
- Operates in the 70 MHz to 6.0 GHz range—covers most licensed and unlicensed bands
- Tunable Channel Bandwidth—<200 kHz to 56 MHz
- Complete dual- or single-channel integrated wideband transceiver on a single chip
- Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
- Wi-Fi, using ESP-WROOM-02 module
- Bluetooth SPP, using HC-05 module, up to 10 meter range
- Arduino Expansion Header (Uno R3 Compatibility), Full HD HDMI Output, UART-to-USB, USB OTG Port, Micro SD Card Socket, Gigabit Ethernet and GPIO Headers
As the pioneering FPGA-based product and design service supplier, Terasic never stops looking for innovating and cutting-edge ideas! This time, we challenge you to conduct a technical review and provide ideas that will ignite sparks of creativity for our flagship product, DE10-Standard. All users of Terasic FPGA board are welcome to participate in this event!
- Intel® Agilex™ F-Series FPGA AGFB014R24B2E2V
- Two QSFPDD connectors for 200/100/40/25/10 GbE network interface
- Four independent DDR4 SODIMM sockets
- PCIe Gen4 x16